TTR 7:1 Gear Reduction Unit for Tamiya Clodbuster

Must have for Serious RC rock crawling fans!

Now with this upgrade your will be able to craw/pull with monster torque even with just a stock motor. This is a fully adjustable Reduction Unit from 2:1 up to 7:1 ratio. (Just change the Pinion Gear)

The gear reduction unit has the ability to adjust the pinion on the motor as well as the pinion on the output shaft going into the clod gearbox. This allows an adjustable range from under 2:1 to over 10:1 Or overall ratios at the wheels from 54:1 to over 270:1!

It also allows the motor position to move for use with stock or modified chassis setups.

• One Complete Gear Reduction Unit (can be use for front or rear)
• High Quality Carbon Fiber and Aluminum Material
• Installation Manual
• All needed screws!
• Pinion Gear is not included, you can use your stock one.

Note: This item will be ship by during the week of September 23. Quantitiy is very limited, so pre-order now! Be the first to own it!